Latest and live tenders published in united arab emirates. Click on any tender to view further details.

supply of hire of low bed trailer for shifting gas tuebine rotor within jebel ali power station for g station gas turbines. job to be done as per actual approved outage. our requirment: multi axle hydraulic low bed trailer 8.00 hrs service time for full day without tra vel time for shifting siemens 2000e gas turbine rotor assembly within jebel ali power station complex multiple trip may needed with in the 8 hrs working time

supply of temp controller heater outlet for air dryer 2tc model no: 2300-j2-i05-07, supply volt: 120 vac, id: e 962109, make: burling instrume nts setpoint 380 deg f part number 7de60dw

supply of hall effect current ttransformer dc-ct, telcon-ht300, range 2000/1, rated current 300a, power supply 15vdc for d station 24v seira c harger.

supply of tube, boiler tube, size- od 38mm x 3.6mm thk, material- 13crmo44, length-3.5m, with material certificates, for super heater-2 of ph-2 aux boilers 6/7/8.

supply of pressure switch; model: 6kc3 103-0c, lower pressure range: 3.5 - 6 bar, diff. pr: 0.5 - 4 bar, connection: 1/2 npt, contact rati ng: 10 a ac 500v, make: meyle

supply of mat finished wallmount toilet roll holder double with face plates have flares edges dispensing area has hemmed edges to prevent inju ry with screws and dowels wall mounted size- 267x115x105mm

supply of diffuser insert for ert, htc at-4800, material ertalyte make eri.

supply of network switch. make: cisco. model: catalyst 2960-x 48 gige, 4 x 1g sfp, lan base. ac power cord uk, c13, bs 1363, 2.5m. sntc-8x5x nbd catalyst 2960-x 48.

supply installation, commissioning of air supply arrangements to dewa cable lab technical specifications # output connection shal l be connected to one inch pipes of length around 30 meters, followed by parallel with 5 individuals of pressure controls 1 to 5 bar with control valves. pipes will be connected to the available air oven in the lab. necessary t junction, fixtures etc. # one indep endent 2 way connection on the mechanical side in the lab. # application is connected to individual available air ageing oven & slic ing machine. # fabrication of outdoor shade for the air compressor, filters etc. # outdoor type suitable to ambient conditions or sh all provide with shaded portions suitable to ambient conditions. # installation of metal air piping system, drip legs, filters, ball valves, filters, dryers, unions, oil water separator, fittings, pressure and flow meter, regulators etc. # minimum 7.5 hp screw air c ompressor oil lubricated with suitable oil, humidity filters, & continuous rating, or suitable one shall be supplied. # input volt age 415 volts ±10%, 3 phase, 50hz. # prime mover of compressor: min. 7.5 hp induction motor with continuous rating or suitable one. # drawing is attached. # type :oil lubricated with suitable oil filters and continuous rating # air flow capacity :40 cfm cubic fe et per minute # receiver tank also kept outside. # operating pressure :7 - 10 bar # noise level:# 70db a at 1 meter distance # su itable soft starter or vfd with digital control panel for smooth operation electrical control circuit with over load and short circu it protection and fault current trip. # mechanical enclosure with suitable ingress protection and all mechanical protection paramete rs # receiver tank minimum 100 liters or around 125 litres. # temperature 10 to 60 deg c # humidity 10% to 90%. # power supply -230 v, 50 hz. # warranty 3 years. # installation and commissioning. # factory test report/calibration certificate.

supply of diecast aluminium enclosure, p/n:gub03, atex eexd iic t6, make: cortem supplied by zeeco.