Notice Inviting Tender (NIT) by the Government Departments Of Uttar Pradesh for Tender For The Work Of Changes Of Damaged Xlpe Cable, Poles & Lines In M & R Scheme Which Fallen Due To Different Reason Under Edd-Ii Hathras - Safe Carriage of following material from Electricty store center Hathras to Pit site of work through the Kacha and Pakka road includingloading and unloading at the respective ends including the cost of arrangement of labour, T&P, etc. which required for proper completion of work.(Distance 00-50 Kms.) 2 8.5 Mtr. long PCC Poles. 3 9/11 Mtr. S.T. Poles 4 11 KV X-Arms, weasal conductor, G.I wire,Disc Insulators, Pin insulators, clamps and otherrequired line material, if any. 5 11 KV XLPE Cable 6 Replacement of damaged 8.5 Mtr. long PCC pole by digging of pits in kharanja/mettalic road and dismantling of all 11KV/LT accessories from the existing / damaged pole and errection of single new pole including Fixing of all accessories With Grouting. 7 Replacement of damaged 9/11 Mtr.Long ST pole by digging of pits in kharanja/mettalic road and dismantling of all 11KV/33 KV accessories from the existing / damaged pole and errection of single newSTP pole including Fixing of all accessories With grouting. 8 Replacement offollowing damaged accessories in 11 KV /LTline - 9 11 KV X-Arms, 11 KV Pin Insulators with Pin &Nut &Bolt , F Clamp 10 11 KV Disc Insulator With Fiting 11 Fixing of T. Channel 12 Errection and grouting of stays complete as per RESPO Norms and as per direction of supervising engineer with Grouting material i.e. cement, sand, brick ballast/stone ballast etc. shall be arranged by the contractor at his own cost. 13 Laying, sagging and stringing and Nozzling / binding etc. ofnew &old ACSR Weasal conductor / GIin 11 KV / LT lines as per RESPO manual and as per direction of supervising engineer. 14 ACSR Weasel conductor 15 ACSR Dog / Racoon Conductor 16 Laying of XLPE Cableas per direction of supervising engineer 17 Digging of proper size of pit for following work of damaged steel support with the provision of temporary support :-Then reinforcement of steel support by welding of 04 Nos. 2 feet long M.S. angle iron of 50x50x6 mm. at equal distance around each pole & also welding of these angle iron with each other by providing M.S. flat of size 35x6 mm. in round. 18 Construction of round plinth around the S.T. Poles / RS Joists / Rails will be done with cement, sand and concrete in 1:3:6 ratio of size 450 mm. dia & 600 mm height (300 mm. under the ground + 300 mm. the ground). The plinth should be plastered with ½ inch thick cement and sand of ratio 1:4 & taper rounding the upper most part of the plinth. The rate will include all cost of material, labour and T&P etc. for completion of the above work which will be provided by the contractor at his own cost. in Hathras - Uttar Pradesh has been published.
The last date of this tender is 13/05/2025, work value is  0 (Refer Doc) INR, EMD is  3000 INR and tender document fees is  1180 INR
For more details call us on +91 92760 83333 for bidding support this tender, GeM, vendor registration (if any) and tender BOQ documents.