Notice Inviting Tender (NIT) by the State Government Of Orissa for Road Works - Trimming Grass And Weeds Removal Of Rubbish Up To A Distance Of 30 M Outside The Periphey Of The Area As Per Technical Specification Clause 201.1Of Mord Specification For Rural Roadsand As Per The Direction Of The Engineer-In-Charge, Construction Of Embakment With Approved Materials Obtained From Borrow Pits With All Leads And Lifts Transporting To Site By Mechanical Means Spreading Grading To Required Slope Compacting To Meet The Requirements Of Table 300.2 And Clause 305 Of Mosrth Specification For Road And Bridge Works 4Th Revision And As Per The Direction Of The Engineer-In-Charge, Providing And Laying, Spreading And Compacting Stone Aggregates Of Specific Size For Water Bound Macadam As Per Specification Including Spreading In Uniform Thickness, Hand Packing, Rolling With Three Wheel 80-100 Kn Static Roller In Stages To Propper Grade And Camber, Applying And Brooming, Crushable Screening / Stone Screening, Binding Materials To Fill-Up The Interstices Of Course Aggregate, Watering And Compacting To The Required Density As Per Per Direction Of Engineer-In-Charge & As Per Clause 405 Of Mord Specification Of Rural Roads 1St Revision, Providing And Applying Primer Coat With Bitumen Emulsion Ss-1 On Prepared Surface Of Granular Base Including Cleaning Of Road Surface And Spraying Primer At The Rate Of 0.70-1.0 Kg/Sqm Using Mechanical Means As Per The Direction Of The Engineer-In-Charge, Providing And Laying Bituminous Macadam With Hot Mix Plant Using Crushed Aggregates Of Grading As Per Table 500.4 Premixed With Bituminous Binder, Transported To Site Upto A Lead Of 1000M Laid Over A Previously Prepared Surface With Paver Finisher To The Required Grade, Level And Alignment And Rolled To Achieve The Desired Compaction As Per Technical Specification Clause 504 And As Per The Direction Of The Engineer-In-Charge, Providing And Laying Semi Dense Bituminous Concrete With Batch Type Hot Mix Plant Using Crushed Aggregates Of Specified Grading Premixed With Bituminous Binder Of 60/70 Penetration Grade Of Bitumen, Transported To Site, Laying With A Hydrostatic Paver Finisher With Sensor Control To The Required Grade, Level And Alignment And Rolling With Smooth Wheeled, Vibratory Roller And Tandem Rollers To Achieve The Desired Compaction As Per Clause-508 Of Mosrt&H Specification For Road & Bridge Works4th Revision As Per Specification And Direction Of Engineer -In –Charge, Reinforced Cement Concrete M 15 Grade Kilometre Stone Of Standard Design As Per Irc : 8 Fixing In Position Including Painting And Printing Etc As Per Drawing And As Per The Direction Of The Engineer-In-Charge, 5Th Kilometer Stone, Ordinary Kilometer Stone, 200 Mm Stone, Providing And Fixing Of Semi Reflective Cautionary, Mandatory And Informatory Sign Board As Per Irc:67 Made Of 1.5 Mm Thick Ms Sheet Duly Stove White Colour In Front And Gray Colour On Back With Red Reflective Border Of 65 Mm Width And Required Letters And Figures With Reflective Tape Engineering Grade And Colour Supported And Welded On 47Mm X 47 Mm X 12 Swg Sheet Tube Firmly Fixed To The Ground By Mean Of Properly Designed Foundations With M-15 Grade Cement Concrete 450X450x600 Mm, 600 Mm Below Ground Level As Per Approved Drawing And As Per The Direction Of The Engineer-In-Charge, 600 Mm Equilateral Triangle, 600 Mm Circular, Construction Of Rcc Guard Posts Of 200 Mm Dia M15 Grade Cast-In-Situ With 20 Mm Nominal Size Aggregate, True To Line And Grade, Tolerance Of Vertical Rcc Posts Not To Exceed 1 In 500 As Per Drawing And As Per The Direction Of The Engineer-In-Charge, New Construction, Painting On Concrete / Steel Surfaces With Epoxy Painting Two Coats Including Prime Coat With Epoxy Paint Approved Brand On Concrete /Steel Surface After Through Cleaning Of Surface To Give An Even Shade As Per Drawing And Technical Specification Clause 1701 And As Per The Direction Of The Engineer-In-Charge, Printing New Letters & Figures Of Any Shade With Enamel Paint Black Or Any Other Approved Colour To Give An Even Shade As Per Drawings And Technical Specification Clause 1701, 3 Letter in Sundergarh - Orissa has been published.
The last date of this tender is 07/06/2021, work value is  9844796 INR, EMD is  0 (Refer Doc) INR and tender document fees is  10000 INR
For more details call us on +91 92760 83333 for bidding support this tender, GeM, vendor registration (if any) and tender BOQ documents.