Notice Inviting Tender (NIT) by the State Government Of Orissa for Road Works - Trimming Grass And Weeds Removal Of Rubbish Up To A Distance Of 30 M Outside The Periphey Of The Area As Per Technical Specification Clause 201.1Of Mord Specification For Rural Roadsand As Per The Direction Of The Engineer-In-Charge, Construction Of Embakment With Approved Materials Obtained From Borrow Pits With All Leads And Lifts Transporting To Site By Mechanical Means Spreading Grading To Required Slope Compacting To Meet The Requirements Of Table 300.2 And Clause 305 Of Mosrth Specification For Road And Bridge Works 4Th Revision And As Per The Direction Of The Engineer-In-Charge, Providing And Applying Tack Coat With Bitumen Emulsion Rs-1 Using Emulsion Distributor At The Rate Of 0.25 To 0.30 Kg Per Sqm On The Prepared Granular Surfaces Treated With Primer & Cleaned With Hydraulic Broom As Per The Direction Of The Engineer-In-Charge, Providing And Laying Bituminous Macadam With Hot Mix Plant Using Crushed Aggregates Of Grading As Per Table 500.4 Premixed With Bituminous Binder, Transported To Site Upto A Lead Of 1000M Laid Over A Previously Prepared Surface With Paver Finisher To The Required Grade, Level And Alignment And Rolled To Achieve The Desired Compaction As Per Technical Specification Clause 504 And As Per The Direction Of The Engineer-In-Charge, Providing And Laying Semi Dense Bituminous Concrete With Batch Type Hot Mix Plant Using Crushed Aggregates Of Specified Grading Premixed With Bituminous Binder Of 60/70 Penetration Grade Of Bitumen, Transported To Site, Laying With A Hydrostatic Paver Finisher With Sensor Control To The Required Grade, Level And Alignment And Rolling With Smooth Wheeled, Vibratory Roller And Tandem Rollers To Achieve The Desired Compaction As Per Clause-508 Of Mosrt&H Specification For Road & Bridge Works4th Revision As Per Specification And Direction Of Engineer -In –Charge, Painting Two Coats Over Wood And Iron Work With Approved Enamel Paint Over A Coat Of Primming, Including Cost And Conveyance Of All Materials To Site, And All Labour Charges Complete As Per Direction Of E.I.C, Reinforced Cement Concrete M 15 Grade Kilometre Stone Of Standard Design As Per Irc : 8 Fixing In Position Including Painting And Printing Etc As Per Drawing And As Per The Direction Of The Engineer-In-Charge, Ordinary Kilometer Stone, 200 Mm Stone, Providing And Fixing Of Typical Informatory Sign Board With Logo As Per Mord Specifications And Drawing. Three Ms Plates Of 1.6 Mm Thick, Top And Middle Plate Duly Welded With Ms Flat Iron 25Mm X 5M Size On Back On Edges. The Lower Plate Will Be Welded With Ms Angle Iron Frame Of 25Mm X 25Mm X 5Mm. The Angle Iron Frame Of The Lower Most Plate And Flat Iron Frame Of Middle Plate Will Be Welded To 2 Nos. 75Mm X 75 Mm Of 12 Swg Sheet Tubes Posts Duly Embedded In Cement Concrete M-15 Grade Blocks Of 450Mm X 450Mm X 600Mm, 600Mm Below Ground Level. The Top Most Diamond Plate Will Be Welded To Middle Plate By 47Mm X 47Mm Of 12 Swg Steel Plate Tube. All M.S. Will Be Stove Enameled On Both Sides. Lettering And Printing Arrows, Border Etc. Will Be Painted With Ready Mixed Synthetic Enamel Paint Of Superior Quality In Required Shade And Colour. All Sections Of Framed Posts And Steel Tube Will Be Painted With Primer And Two Coats Of Epoxy Paint As Per Drawing Clause 1701 And Annexure 1700.1 Of Mord And As Per Direction Of The Engineer-In-Charge, Providing And Fixing Of Retro Reflective Cautionary, Mandatory And Informatory Sign Board As Per Irc:67 Made Of 1.5 Mm Thick Ms Sheet Duly Stove White Colour In Front And Gray Colour On Back With Red Reflective Border Of 65 Mm Width And Required Letters And Figures With Reflective Tape Engineering Grade And Colour Supported And Welded On 47Mm X 47 Mm X 12 Swg Sheet Tube Firmly Fixed To The Ground By Mean Of Properly Designed Foundations With M-15 Grade Cement Concrete 450X450x600 Mm, 600 Mm Below Ground Level As Per Approved Drawing And As Per The Direction Of The Engineer-In-Charge, 900 Mm Equilateral Triangle, 600 Mm Circular, 600 X 450 Mm Square, Construction Of Rcc Guard Posts Of 200 Mm Dia M15 Grade Cast-In-Situ With 20 Mm Nominal Size Aggregate, True To Line And Grade, Tolerance Of Vertical Rcc Posts Not To Exceed 1 In 500 As Per Drawing And As Per The Direction Of The Engineer-In-Charge, New Construction, Painting Two Coats With Approved Synthetic Enamel Paint Including Cost And Conveyance Of All Materials To Site And All Labour Charges Complete As Per Direction Of E.I.C, Providing And Laying Of Hot Applied Thermoplastic Compound 2.5Mm Thick Including Reflectorising Glass Beads @ 250 Gms Per Sqm Area, Thickness Of 2.5Mm Is Excusive Of Surface Applied Glass Beads As Per Irc:35 . The Finished Surface To Be Level, Uniform And Free From Streaks And Holes, Printing New Letters & Figures Of Any Shade With Enamel Paint Black Or Any Other Approved Colour To Give An Even Shade As Per Drawings And Technical Specification Clause 1701, 5 Letter in Sundergarh - Orissa has been published.
The last date of this tender is 07/06/2021, work value is  14231909 INR, EMD is  0 (Refer Doc) INR and tender document fees is  10000 INR
For more details call us on +91 92760 83333 for bidding support this tender, GeM, vendor registration (if any) and tender BOQ documents.